Adding VST effects 2 audio channels

TranceAddict Forums (www.tranceaddict.com/forums)
- Production Studio
-- Adding VST effects 2 audio channels

Posted by mystikal on May-25-2005 15:54:

Adding VST effects 2 audio channels

Hi everyone, this is my first post here although i have been looking through this site for some time now.

I have a question 4 ya all, is it possible to apply vst effects, reverb, compression, eq, etc, to audio channels in realtime via ADAT.

My setup consists of a virus xl rack, motif rack, and ex7. I have 8 individual mono outs,(4 from each rack) as well as my stereo outs going into cubase sx through my behringer ada8000 and my emu1212.

i know that i can apply effects directly from my sound card to each ADAT channel, but i would rather use proper vst effects. without first having to mix down to audio. thanks and respect.

Posted by IDarkISwordI on May-25-2005 16:14:

Hey. VST effects of course can be used in realtime! If your using an all hardware setup then these will probably suit you best.

Hardware VST Hosts:
PlugZilla
Muse Receptor

There are a few other companies I have talked with and they tell me theyll be following with thier own hardware VST hosts but not until next year. Hope this is what you were looking for .

Cheers,
Zac

Posted by mystikal on May-26-2005 05:04:

Hi IDarkISwordI

Thanks for the quick reply and the information about the hardware hosts, i will look into them, but its not really the answer i was hoping for as my credit card is already maxxed out.

Its really frustrating cause in cubase sx, in the mixer i can see my 8 mono audio channels and i can adjust the eq and add vst effects to the channels but it has no affect on my sounds.

Guess i will just have to continue to use the effects on my emu1212 for now.

Thanks
baz