TranceAddict Forums (www.tranceaddict.com/forums)
- Music Discussion
-- car sterio ideas
car sterio ideas
How would it be if I used a
one MRD-M501 � 550 Watt Mono Power Amp:
� 550W x 1RMS (2ohm)
� 275W x 1 RMS [4ohm @14.4 V≤ 1% THD+N]
� S/N 60 dBA (Ref: 1W into 4ohm)
� 8 Volt Input � Buffered Pre-Out
to run
two 100w rms - 200w rms rockford T1692C speakers
off an Alpine 9831 deck with the following features:
Preamp Outputs 3 Pair
Continous Power Output 4 x 23Watts
Maximum Power 4 x 50Watts
Preamp Voltage 4Volts
Does the amp have the capability, because I don't feel like the deck is doing the speakers justice. Also if possible I have front speakers that I might like to put off this amp too.
two 4" 2 Way Speakers
Power Handling 50 W RMS, 100 Peak
Frequency Response 75 Hz to 20KHz
don't think you can use a mono amp with two speakers buddy
could be wrong, but i think that would involve lots of wiring, and you'd lose all your 'stereo' sound, ie left and right....
you're better off getting a 2 channell amp, one for each speaker
also that way you don't need as much power
Those mono amps are used pretty much for subs which just use a single channell
you really need to get an idea of what you want
powering two 6x9s with a crappyt overpriced mono amp will sound like total garbage.
get yourself the alpine head unit, with V-Drive power, use it to power your 4 internal speakers, and get yourself a Hifonics or other mid grade amplifier to power subwoofers with money you will save.
Or purchase a 4 channel amp to power all 4 of your internal speakers.
Im a car audio salesman/installer by trade, Ive been in the business for about 7 years, and I know what im talking about.
send me a PM or IM to talk so I can help you make a proper decision.
isnt this in the wrong section?
| quote: |
| Originally posted by WiKKid sKiLLz isnt this in the wrong section? |
Powered by: vBulletin
Copyright © 2000-2021, Jelsoft Enterprises Ltd.