TranceAddict Forums (www.tranceaddict.com/forums)
- DJ Booth
-- Broken Headphone Connecter in Mixer
Broken Headphone Connecter in Mixer
So I have managed to break my headphones 1/8 to 1/4" connecter in my XONE:62, about the first 2 milimeters of it is stuck in my mixer at the bottom of the headphone jack. I have tryed and looked for many things to try and get it out, but no luck, can't seem to find pliers that are thin and long enough to fit into that port...
Any suggestions are appreciated!
Jimmy
cry?
no, just get a long thin thing like a bamboo kabob skewer and put a tiny dot of super glue on the end, be really careful and put it down teh jack till it hits the broken adapter then when the glue sets, pull the whole lot out.
or take it to your DJ store and get them to take it out for you.
I had thought about doing something like that, but was a bit hesitant to try it...
Another one
Take the faceplate off, push the jack out. Avoid that glue thing, I never heard anything so stupid and dodgy at the same time. Screwdriver FTW.
a magnet, maybe?
This might interest you :
http://www.tranceaddict.com/forums/...threadid=452713

Good job, I couldn't find it... Did you sort out your 92 then since ?
| quote: |
| Originally posted by Shini cry? no, just get a long thin thing like a bamboo kabob skewer and put a tiny dot of super glue on the end, be really careful and put it down teh jack till it hits the broken adapter then when the glue sets, pull the whole lot out. |
| quote: |
| Originally posted by Mmanu Good job, I couldn't find it... Did you sort out your 92 then since ? |
Powered by: vBulletin
Copyright © 2000-2021, Jelsoft Enterprises Ltd.