Suggestions For Partitioning off Equipment Area (Picture Attached)

TranceAddict Forums (www.tranceaddict.com/forums)
- DJ Booth
-- Suggestions For Partitioning off Equipment Area (Picture Attached)

Posted by Jarvmeister on Jul-31-2008 11:43:

Suggestions For Partitioning off Equipment Area (Picture Attached)

Basically, I want to partition off this little area, to give a booth type effect. Any suggestions on what I could use? I would like it to run along the front and along the left hand side as if you were looking at it from behind the equipment. Poor image quality - sorry it's a mobile phone.....

Posted by Domesticated on Jul-31-2008 12:18:

Build a shit frame out of timber studs and use plywood sheets rather than plasterboard, then paint it.

Cheapest, sturdiest and easiest way.

Posted by Jarvmeister on Jul-31-2008 12:42:

Hmmmm,

I would, but I am REALLY bad at anything DIY. I can get help if absolutely necessary, but I'd prefer an off the shelf solution that looks good.

And if I made it it would not look good.

Thanks though.....

Posted by Domesticated on Jul-31-2008 14:42:

Off the shelf you have very few options...

Posted by Import on Jul-31-2008 15:34:

Well you could just buy a big black tablecloth and tape it to the front/side of that desk. It wouldent really improve the situation, just make it look abit better

Posted by DJ RANN on Jul-31-2008 20:39:

quote:
Originally posted by Jarvmeister
Hmmmm,

I would, but I am REALLY bad at anything DIY. I can get help if absolutely necessary, but I'd prefer an off the shelf solution that looks good.

And if I made it it would not look good.

Thanks though.....

Dude, make a design, go to your local lumber yard, Home Depot, B&Q, whatever shop that sells and cuts wood, and ask them to cut the wood for you. The ask them how you should join it all together. Seriously it will work out really cheap and fit exactly what you need.