Unmute the channels, then right click on their mute buttons and click init song with this position.

thanks alot

It seemed to have work for a few channels..

But now when I play the song in FL. A few of the channels randomly mute and unmute themselves and mess up the whole song because they randomly cut off...I tryed doing "init song with this position" on all the channels but they still seem to do it while in play... whys that?

& is there anyway I can clear all the volume ADJUSTMENTS or whatever I have done during recording so that the song plays without adjusting anything?

Any suggestions?

Last edited by midaV on Apr-17-2004 at 22:54

The muting/unmuting was recorded as automation data in whatever pattern was selected when you were recording. Right click the mute switch, volume control or whatever and select "edit events". You will see the automation here, and you can do a "select all" and delete. If you don't see any automation data, I think by keeping the window open and scrolling through the patterns you can eventually find which pattern is doing the muting. If you want to record your automation, its best to make a new pattern for it so you can keep track of what is going on easier.

quote:

Originally posted by gcrasher You will see the automation here, and you can do a "select all" and delete.

Just do delete all, its quicker

hey actually in your sampler browser you'll see a folder called, "Current Project"... It will have a list of all patterns holding automations, and little entries you can click on to directly bring them up for editing.

See, init song with position will tell the song to STARt with those channels on mute, but if you have any patterns with any type of automatation, they may tell the channel to unmute the channel somewhere into the song. So, as Fuq said, might be quicker to delete the channel then seatch through each pattern for the automation. its up to you.

___________________

thx alot guys