well since the headphone jack is already broke... put some super glue [or EPXOY (the things you can do with epoxy!)] at the end of a stick. Pop it out

dunno pull the mixer apart! (to a certain extent!)

quote:

Originally posted by Orbital32 well since the headphone jack is already broke... put some super glue [or EPXOY (the things you can do with epoxy!)] at the end of a stick. Pop it out

Ok to clarify things:

the headphones are hdj1000s. the actualy 1/4 jack is not damaged, it is the adaptor jack that we use for plugging the h/ps to the mixer that like split in two. so the screw on part is still on the headphones just that the tip of it is stuck inside.

there are 2 thin metal strips thats all I can see in the hole.

If i try to superglue it may not stick well coz the surface area is so thin.

___________________
https://youtube.com/@raulleemusic

https://instagram.com/raulleemusic

quote:

Originally posted by mzvirbulis dunno pull the mixer apart! (to a certain extent!)

The mixer is a DJX700. I unscrewed the top panel to see if u could remove the stuck piece from underneath the headphone jack hole thing.

But theres something blocking so thats out of the question.

I've tried tweezers but like I said earlier those metal 'legs' are too slim so its hard to get a grip.


mannnnnnnnnnn... this sucks.

___________________
https://youtube.com/@raulleemusic

https://instagram.com/raulleemusic

What I'd do is solder wires onto the little wire legs and pull that ****** out.

Make sure to try and solder as much of the leg things to the wire as possible (solder over the greatest length of the leg as possible).

Possibly depends on how much you can see/ size of your soldering iron tip I supose though.

Without knowing the mixer it might be easier to try to properly take it to bits.

___________________
If you can read this, I'm seriously fucking bored.

I'm with Orbiutal on this one, get a matchstick, whack some araldite (epoxy resin) on the end and, very carefully, stick it too the offending plug.... done this before and it works a treat.

stick something plastic just a **** hair bigger then the whole of the jack that is stuck.. ram it in and yank it...

Jay

what the method to take out a broke light bulb? I think a potato.. heheheh use a potato to take it out

Rafale, did you try to unscrew the hole phone socket?

You should just replace the complete headphones socket.

That happened to me once, but it was the Tip of the 1/8 - 1/4 inch
adaptor.

Had to replace the whole thing. There's really no way to get it out
without damaging the pins in the process. Go to your local Radio
Shack, and, pick up a new 1/4 Stereo Socket.

___________________
OMNIFEX

groovable:
Yeah I tried to unscrew the top panel.. but beneath the headphone socket theres like a lid or sumthing which I don't wanna remove coz it looks pretty delicate!


OMNIFEX .. won't I need to wire the thing back to the mixer parts.. that will be quite risky as well.. might screw it up.

___________________
https://youtube.com/@raulleemusic

https://instagram.com/raulleemusic