I have this track I want to remix, I have formated my Harddrive to reset everything.. I burned all my project files..

I loaded my previously saved project, only problem now is, that Cubase do not find my z3ta+ patch that I used with the song, although I have z3ta+ installed..

I get the error message in Cubase that "z3ta+ Not Connected"

any idea?

___________________


http://soundcloud.com/subtara

That message usually means SX cannot find Z3ta ... check if Z3ta is listed within in your vst panel .. theres a good chance that you might have to reinstall it again.

If so .. then closedown cubase .. uninstall zeta from the control panel ... reboot pc and then install it again .. then boot up cubase and load your project

If not just find the z3ta.dll and move it into Cubase SX VST folder. Should be able to work with that

___________________
Lets !!!

Production Site
-=:::Currently in the stage of new tune:::=-

press F11 and check that 1. z3ta is in the instruments panel and 2. that z3ta is activated (the blue light in the VST instrument panel is on next to z3ta+).

You get that message when an instrument has either been disconnected or switched off. If it is disconnected and you did not save the patch, then it is probably gone, but if z3ta is only deactivated, then the patch should still be there.

___________________
1 out of every 4 people in this country are mentally disturbed. Look at your 3 closest friends. If they seem okay, then you're the one.