quote:

Originally posted by PEZ68 think it may interest some people here : http://www.mio.co.za/printpage.php?id=238

i like this part

quote:

Disclaimer: MIO Entertainment nor the author will be held responsible for any damage done to any equipment arising from this tutorial. If you choose to follow these tips, you do so at your own risk. Please be careful and bear in mind that if done correctly, the modifications suggested by the author can be easily undone. Good luck!!

If you cut both the orange and the yellow wire instead of just the one the green led won't turn on anymore. You can also disassemble your pitch fader and take out the little bearing to remove the click.

___________________
I've never been able to eat a whole baby.
Kill the women. Eat the children.
It's just one of those days where you want to bend over everyone you know and kiss their ass goodbye with a big sideways boot.

Latest Mix

Last edited by Zild on Jul-04-2005 at 19:25

thank you soooooo much for this site... i finally fixed the pitch on one of my tables...

so thank you for this info

Glad i bought the M5gs... no minor annoyances

The link is dead. Anyone got another site, i have to recalibrate mine.

when can you tell its time to recalibrate.

quote:

Originally posted by DJ_RoKo when can you tell its time to recalibrate.

If you look at your strobe it has a key that tells you at what pitch value the dots will remain stationary. Check your decks against the standard values. -3.3%, 0%, 3.3%, and 6%. Chances are that unless you just bought your deck new then the values will be off a little bit.

It really isn't that big of a deal unless your pitch fader is far off the mark or it drifts and you have trouble mixing when you know you shouldn't be having any trouble.

___________________
I've never been able to eat a whole baby.
Kill the women. Eat the children.
It's just one of those days where you want to bend over everyone you know and kiss their ass goodbye with a big sideways boot.

Latest Mix

When the green 0 pitch light comes on should the 2nd dot be stationary even if the pitch is off? therefore u would have two zero's? or is the zero lock obsolette when your pitch fader is off? i think i need to recalibrate one of my techs, i always seem to have trouble on the same one!

Well, the zero will move on you after awhile, so you end up having a zero when the green light is on, and a zero somewhere on the pitch that isn't labeled zero, but is very close. That gives you two zeros. It is possible to disable the quartz lock circuitry to prevent this from happening.

___________________
I've never been able to eat a whole baby.
Kill the women. Eat the children.
It's just one of those days where you want to bend over everyone you know and kiss their ass goodbye with a big sideways boot.

Latest Mix

any ideas how to disable this zero without any soldering, or is it required? cos it does give me trouble, i would rather recalibrate it though any sites where they show how to do it?