|
dude. dont worry about it. the oldschool way to mix is to have one ear on the headphone monitoring the incoming track, one ear listening to the monitor.
fine. but what happens when you have a crap monitor with a delay? what about when you're spinning with more than 2 decks? there is nothing written in stone about how to really monitor.
it seems older DJs will tell you to always use the one and one method, because this way you can be sure of what the people are hearing, but i've seen for instance, a friend of mine who plays techno on 4 decks, as soon as he hears something go a bit out, puts both cups on. he says he'll be 50% more accurate this way, even tho he hates it.
also, if the monitors aren't static (ie. you can move them, theyre on pedestals) and they're really loud, you can turn them to face the crowd, or at least to not face you directly, which in turn will allow you to mix with your headphone volume a LOT lower, consequently conserving your ears and your headphones better.
furthermore, if you have a mixer with master/cue option, you can hear exactly what the crowd hears, removing the necessity of a loud monitor, in turn, allowing you to mix with your headphones even lower.
however, one must admit. you should still know your way around the one and one method, since some mixers have this as the only option. also, it's wise to take the phones off now and then, cuz shit happens. ie. last night i was spinning on a Xone:92, and i mixed a track in as i would normal. 2 minutes later, i noticed the HP filter was activated at halfway, so the people were getting no thump. but when i brought it in, i got a kickass reaction, so it wasn't too bad.
edit: Tony Morello put it best.
___________________
check out my guest mix for OndaSonora Podcast (aug.2009)
|