Loading older banks inside z3ta+,
they miss
Quality settings, sometimes even causing high CPU spikes and very
loud annoying noises (Be careful with your ears!).
Also Arp-settings may be not correct with some patches.
There's a workaround, if you have the older version 1.4.
Load and Resave the older banks with the older Version, after that
there are o.k. in V 1.5.3


I found this here
http://www.kvraudio.com/forum/viewtopic.php?p=4138907

Got a big white noise sound out of it once, scared the shit out of me.. have not used it since.

___________________


http://soundcloud.com/subtara

yes i have experienced this many times thus generally trying to stay away from z3ta even though its a decent synth

___________________
Mr Kaizen on Soundcloud

i always cut above 12khz until i master the track, this keeps the white noise out of the mixdowns.

z3tas my #1 goto and I never had a single issue with it

sylenth however fucks my computer up anytime I open it. Guess it depends on your set up/software in general.

I find Z3ta very cpu exhausting and Sylenth completely the opposite, is weird. But i've used sylenth a lot on a project and the cpu is quite low (70% ) but the RAM usage is real high, almost 2gb...

quote:

Originally posted by Rodri Santos i always cut above 12khz until i master the track, this keeps the white noise out of the mixdowns.

WaT?

___________________
New Mix: March 2010 Promo
Soundcloud|Facebook

easy , go to the eq on the sounds and reduce at 12khz , there's always some residual noise , you cut it and at the end listen and think if it plays an important role on the sound or if it could be deleted.