Did you export the kick in FL?? If so it may have had a limiter on the master

___________________
*** Sig edited -> no banner advertising in sigs
http://promote.beatport.com/images/labels/1253/12531-blue-468_60.jpg

quote:

Originally posted by Ry Thomas Did you export the kick in FL?? If so it may have had a limiter on the master

I did not actually, I just dragged and dropped from the same source where the FL Studio one was dragged and dropped from. Actually, I never had this problem before...

I opened up a Cubase SX 3 project where I have a kick loaded whose volume by default was at -0.00 and was peaking at -08.25dB, which is perfect. I then Imported the same kick right under it in a new audio track and it played at -00.00dB (under the default volume. -0.00).

I just can't understand what happened?

Circular panning law in FL, in the general project settings.

___________________

quote:

Originally posted by Stef De Roux Circular panning law in FL, in the general project settings.

What would the equivalent be in Cubase (in terms of dB, I mean)?

quote:

Originally posted by Feonix What would the equivalent be in Cubase (in terms of dB, I mean)?

No no, go to the general tab of project settings in fl, turn off circular panning law and you will get the same results.

___________________

quote:

Originally posted by Feonix What would the equivalent be in Cubase (in terms of dB, I mean)?

I'm looking to get the same results in Cubase SX 3

I think FL is -3db, from memory.

Project Setup -> -3db