Is this true for Z3Ta (Be careful with your ears!) ??
Loading older banks inside z3ta+,
they miss
Quality settings, sometimes even causing high CPU spikes and very
loud annoying noises (Be careful with your ears!).
Also Arp-settings may be not correct with some patches.
There's a workaround, if you have the older version 1.4.
Load and Resave the older banks with the older Version, after that
there are o.k. in V 1.5.3
i always cut above 12khz until i master the track, this keeps the white noise out of the mixdowns.
Nov-08-2010 19:33
DJ Robby Rox
Longterm Newbie
Registered: Apr 2007
Location: Tiestoland
z3tas my #1 goto and I never had a single issue with it
sylenth however fucks my computer up anytime I open it. Guess it depends on your set up/software in general.
Nov-08-2010 20:41
Rodri Santos
Supreme tranceaddict
Registered: Sep 2009
Location: Milan
I find Z3ta very cpu exhausting and Sylenth completely the opposite, is weird. But i've used sylenth a lot on a project and the cpu is quite low (70% ) but the RAM usage is real high, almost 2gb...
Nov-08-2010 21:00
kitphillips
is actually a guy.
Registered: May 2006
Location: Sydney, Australia
quote:
Originally posted by Rodri Santos
i always cut above 12khz until i master the track, this keeps the white noise out of the mixdowns.
easy , go to the eq on the sounds and reduce at 12khz , there's always some residual noise , you cut it and at the end listen and think if it plays an important role on the sound or if it could be deleted.
) but the RAM usage is real high, almost 2gb...
