Avoid to use easy to damage the wood alcohol, stimulating and corrosion chemicals such as detergent.
Wooden chest, at ordinary timeshome improvementas long as it is ok to clean dishcloth, but if there is dirt, may be appropriate to use soap or neutral detergent, already wet cloth to wipe.
Ultraviolet ray of woodiness furniture also has a destructive power, therefore, appropriate use of the curtain cloth curtain or avoid insolation is necessary.
For waxing, had better choose high concentration and solid, does not contain the silicon content of wax, so as not to damage the paint.
Deformation caused by improper coating processing board type furniture parts
Parts caused by pile deformation in production, some operators for convenience, will board a piles up at will, or a stack board of clear, have more very person will board a leaning on the wall, the plate piece into the next procedure before it happened because of the weight of its own. Painting processfurniture row caused by deformation in the process of finishing, of technology and the improper use of raw materials, along with the change of the coating inner stress and make the plate deformation occurred change curve. Finishing the influence of be bored with child when finishing on cupboard door parts, many manufacturers to reduce the cost more than the pig blood be bored with child or glue modulation of be bored with child, because these two kinds of be bored with child contains a large number of moisture, board type furniture commonly used substrate, medium density fiberboard (MDF) and hygroscopicity of particleboard and special strong, so that when one side of the door plank parts not tu be bored with child, on the other side on the containing water of be bored with child after will make door parts single moisture absorption and deformation.
Drying process of the influence of the factory in production, after the board a slap on the be bored with child or coating, shall be conducted on a drying rack natural drying, if thefurniture reviews frame of the strut is too thin or rough, can also cause a cupboard door components in coatings drying process found in bending deformation. Paint coating after curing the influence of the internal stress will form a coating¡£