I tried to beatmatch with ableton and the warping works just fine.
But now I want incoming track to reach it's original bpm and I try to automate but I can't change the value to the exact BPM of the track.
Also I would like to know if there is a possibilty to loop more then one point for a track...
Should I use two different audio tracks to loop two points?
Douuble click the tempo on the top left corner and type in the original tempo. Copy the track and just trim the copy to the size of the loop you want, there's your loop, then you can make as many different loops as you want.
Cogito, ergo sum.
Your imagination is only the beginning
Bogota Distrito Capital - Millos
Forza Milan
Jun-06-2006 20:35
The Drow
Super Programmer
Registered: Apr 2004
Location: Israel
quote:
Originally posted by jahnlay
Go to the song tempo track in your master track and automate the tempo by drawing in the new tempo changes.
well but it doesn't automate to the exact bpm.
And also when I changed the min/max tempo (just to mix between two tracks) then it trainwerked.
@IKKI-ZUVK: Their tutorial is not enough for me.
It doesn't explain how to exactly raise the bpm to the point I want.
I know how to automate... I just need to paste the exact bpm.
Should I change the bpm druing the mix? maybe I'm not doing something right...
Put Ableton in "MIDI Assign " mode and apply a knob or slider from your MIDI controller to the tempo.
And if you have your tracks warped correctly and are triggering your clips on time.. it should loop/play infinityl with never getting off sync.
I prefer my global quantization set to 1/32.
Jun-18-2006 22:54
The Drow
Super Programmer
Registered: Apr 2004
Location: Israel
quote:
Originally posted by WirelessEyes
Put Ableton in "MIDI Assign " mode and apply a knob or slider from your MIDI controller to the tempo.
And if you have your tracks warped correctly and are triggering your clips on time.. it should loop/play infinityl with never getting off sync.
I prefer my global quantization set to 1/32.
I don't have a midi controller.
I need to know how to change the automation's value of one dot to an exact value...