|
| quote: | Originally posted by chojin
thanks for the good advice, i was expecting a lot more replies like kid nyce's life enriching post. |
i'm glad i enriched your life with my post!
ok I'll be seri-oso with the topic...
If you're computer is just rebooting then it has to be an out-of-phase signal your psu is sending to your computer. Any "short" in a motherboard (backwards placed internal USB cable) will cause the mobo not to boot so that's out of the question. You are getting power to you mobo but it's not retaining and holding an in-phase signal.
Either problems can be
1-PSU is sending out-of-phase signal to your mobo
2-Mosfets on your mobo are overheating
3-Look at your PWM temps (mosfets and power regulators located next to the cpu slot (small black box with 3 prongs coming out) you need a soft read which is usually supplied with motherboards (ie: uguru by abit) - it'll give you digital temp read outs about your mobo. if your PWM temps are high, that means the circuitry in your mobo is getting hot which will cause a blip in (out-of-phase) signal to your cpu thus causing it to reboot.
4-RAM, nintendo-cartridge style hot-breathe-clean the connectors at the bottom of the RAM, use soft cloth to wipe.
That should take care of all HARDWARE faults.
-note-with the case open, I'd recommend adding some more Artic Silver to your cpu heatsink just for sanity-sakes. (Artic Silver = Thermal paste)
On the soft side
1-Boot to safe, run an AV scan
2-Boot to XP, run an AV scan
3-Check active services/messages running on the computer
4-XP Update
5-DL latest mobo drivers for your mobo
If all else fails, resort to the previous method stated earlier by myself.
ctrl alt del multiple times while humming southern sun...it should do the trick!
___________________
I PUT TRADEMARKS AROUND YO MOTHAFUCKIN EYE
JUST ME N YOU
|