Have got Upper and Lower PFM part set to Ch 1. have also set perf ctrl ch to 1 as well. And midi out on FL is set to channel 1. Still no dice!

Nightmare!

Are there any settings in FL that i'm poss missing? I wish the JP had a midi light on it, so that I knew midi was getting through...


PC

___________________
Trance is our religion and Armin is our god!

Check on the JP if Local Switch is set to ON.

And if it is, its your settings in FL

___________________


http://soundcloud.com/subtara

When I had a JP I had no luck unless I connected my MIDI out on my MIDI interface (connected to my PC) to the KBD IN of the JP. I never used the MIDI IN on it, but I guess I was using it only in performance mode according to this:

http://www.midicase.com/JP-8080/jp_midi.htm

edit: also, doesn't FL use a port along with a MIDI channel? I seem to recall having to set that to 0. I bought Ableton once I got more than 1 piece of hardware though, it was just not working smoothly in FL, but that was version 5 I think.

Try this: In FL go to Options and make sure Enable MIDI Output has a tick on it

quote:

Originally posted by paulc_dj I am having problems getting FL studio to "control" my JP. I am using a midi out and I just can't get the JP to respond. I have plugged my controller keyboard into the KBD IN midi input and I have 2 midi cables running from and to my breakout box of my M-Audio 2496 PCI card and in the midi in/out respectively. but still no playback of the midi notes with the patch on the JP. Any ideas? PC