I don't know what i did...but for some reason, my two cd players that are hooked up to my DJM are only playing out of one headphone cup, one speaker, and moving one of the two led bars on my cd recorder. My two tt's are working normal...anyone know whats going on?

quote:

Originally posted by zizack I don't know what i did...but for some reason, my two cd players that are hooked up to my DJM are only playing out of one headphone cup, one speaker, and moving one of the two led bars on my cd recorder. My two tt's are working normal...anyone know whats going on?

are both RCA channels channels from the CD decks connected to the mixer properly?

yes, as far as I can see. I have two seperate table top cd players...one Denon, one Pioneer and they are both only playing out of one side...i think the right.

Definately sounds like a problem with connecting wires and not the mixer.

Well,

On my DJM600 I plugged in my 2 TT's into 2 & 4 with it set on Stereo. But 2 would only produce sound out of the left channel. While 4 played fine.

Although if I switched it to Mono it would play out of both TT's although 2 would be slightly lower.

So... I swapped 2 to 3 and switched it back to Stereo, and it works fine. No ideas what is going on.

___________________

Current Tune:
Ferry Corsten - Junk (Ant Smith Re-Work)
Sunset @ Zoo Bar - 02-2007
www.sunsetnights.co.uk

I know its probably obvious, but did you make sure you plugged in the RCAs for the CD players into the Line Ins instead of one side into the Line In and one side into the Phono In? Since there are 4 RCA plugs for every channel, make sure they are both plugged into the correct two inputs. That could easily explain why you're only getting sound out of one side.

___________________
Helping girls make bad decisions since 1979

I figured it out. It was the RCA cables...I need new ones. It's just weird that both RCA's would get fcked up at the same time. Everythings fine now. Thanks