I'm QUITE sure Numarks manual do not have disassembly instructions. Perhaps a service manual, but I am also quite sure that Numark has no service manual for such crappy turntables.

Here's how you disassemble most turntables:

Remove the platter and put the turntable upsidedown (use a pillow or something to support, be careful with the arm!). There are usually 8 screws over here. Remove those and you can take off the bottom. From there, it's a piece of cake

___________________
Gear Specialist

Last edited by DjVash on Sep-05-2004 at 09:45

How do you remove the platter ???

For like a technics I've been trying and I can't seam to work it out, I just don't wanna screw anything too.

Yea, how do you remove the platter?

___________________

quote:

Originally posted by DJ Tom Yea, how do you remove the platter?

Just pull them off...

Remove the slipmat. There should be two holes there, large enough for your fingers (there should be another hole there if it's a belt drive). See if you can get a grip and pull (don't be afraid to use excessive force, some platters are really tight).

___________________
Gear Specialist

I'll take them apart for you buddy, just give me a 24pack and a sledge hammer.

Anyway, just take them apart screw by screw and remember how it goes together, also post pics of them after your done, I wanna see these, and don't forget to sand them abit so the paint has something to stick to.

They are apart, man what a pain in the ass! Picture to come once they are done!

___________________

I have numark 1510's. What a sucker i was...

___________________
sig edited: sig exceeds size limits. please resize