i have my tables hooked up to a numark dxm-06 mixer.. my problem is that when the record is spinning and the needle on it, the mixer isnt picking up the music and the channel lights do not become lit as to display the volume. someone know why this is? i have hooked my turntables up to a home stereo system before and i know they work and the mixer is brand new out of the box never been used. please let me know as to why my mixer is not cooporating !
___________________
Oct-02-2004 23:46
beats and beeps
Guest
Registered: Not Yet
Location:
This might be obvious, but check your gains. Also make sure you hooked the tables up to the "phono" imputs not "line in"
Oct-02-2004 23:58
djtrinity
....i have nothing to say
Registered: May 2002
Location: NYC
make sure u have the input on phono and not line and the crossfader is on the channel your using or in the middle
everything is set to pick up channel one and not master. blah, don't know whats up.
___________________
Oct-03-2004 14:52
sleepydragon
Supreme tranceaddict
Registered: Oct 2003
Location: doncaster, england
ive got a dxm06 aswell r the level lights lit up at the bottom when u switch the mixer on? cose they should be.
also this may seem they a dumb question but have u switched the mixer on with the switch at the back. make sure the switch next to the upfader is pointing at phono aswell
i cant really think of anything else that could be wrong with it
if there was a problem with the stereo, you should get a signal on the VU meters on the mixer.
check the back of the mixer, there is also hamster switches there for line/phono input (for some reason), so make sure they are all on phono
___________________
MUGGETS
Oct-04-2004 09:00
sleepydragon
Supreme tranceaddict
Registered: Oct 2003
Location: doncaster, england
ive just tested my mixer and i think tu face is right when something is set to line the lights dont apear check every single switch and put it on to phono.
i forgot about them stupid little switches at the back
