|
Recording From Vinyl To MP3 (Help!!)
|
View this Thread in Original format
| dj_cuba |
Hey Peeps :)
I've Just brought a turntable for recording vinyl onto my computer, seeing as decent trance is rarely released on cd singles these days :(
The problem is that I have two left/right Auxillary output leads on the back of my turntable, and I need to convert it into a stereo line in jack so I can plug it into my soundcard.
At the moment Iam having to connect my turntable to some real ty pc speakers and then from the headphone jack to the line in on my soundcard which gives quality sound.
Basically I need advice on how to connect it up :)
All advice appreciated ;)
p.s Iam also having trouble with pops/crackle appearing in the recordings, I have just brought a top quality stylus to stop this happening but it's still there, any advice on this would also be appreciated :cool: |
|
|
| trance[]control-fan |
| well you should get new needles....get some 60 dollar ones or higher...also it just could be the record it selft.. |
|
|
| TranceGeek |
| buy a rca to 1/8" converter and connect your turntable directly to line in of sound card... the recording will be really quiet because you're not going through a mixer, but thats fine since you can then edit the ripped track with software (ie. wavelab etc.)... |
|
|
| nickmahoney |
i suggest purchasing a PreAmp from radio shack.
a standard setup will be RCA connections (red n white phono plugs) that go into a mixer's phono input. a phono input on a mixer is different than an aux or a line input because it boosts the week signal by almost 20dB (if i remember). if you are gonna skip on the mixer (egad!) you can pick up a preamp.
then pick up whatever adapter you need to convert to the 1/8" stereo plug (standard small headphone plug), but dont get the adapter at radio shack. there adapters are notorious for low fidelity and ty quality. better off at guitar center or even circuit city if you cant find them anywhere else.
pops and crackles may be a side effect of noise from not grounding the turntable. with no mixer, i can see how you could forget to do this. make sure you ground the table.
also, make sure when you go to volume properties you go to advanced and select RECORDING. then be sure to mute the mic by clicking on "select" under the line in control. sometimes a nonmuted mic can be confused for low fidelity.
good luck
cheers
nm |
|
|
|
|
