|
Roland MC-505 Users plz read
|
View this Thread in Original format
| JP8000Lover |
Can someone please tell me if the mc-505
transmits any controller data while the cutoff or
resonance knobs are being turned? If so, which controller
numbers are they? I have a mc-303 and it does NOT transmit
any controller data at all for the cutoff or resonance!!
BAD ROLAND!!! :whip::whip: VERY BAD!!! :whip: :whip:
Cheers!
[email protected] |
|
|
| mantisnl |
| i think this thread will be better of in the production studio forum:rolleyes: |
|
|
| TraNcerke |
| I have an mc505 and it sends and receives the most important midi data -including cutoff, resonance, volume, ...-, actually it has loads of midi improvements over the mc303. But don't expect too much from it. After all its a budget all-in-one system. It is nice to start with though. Especially the synth engine is nice. 4 layers of different samples is nice and with some fine tuning you can fatten things up nicely. But if you want real fat sounds go for (virtual) analog synths. Another good point is the x0x sequencing style.. it rocks for recording drums. Check it out in your local store and if you like it , you could get one cheap on ebay i guess :tongue3 |
|
|
|
|
